Contents of Release

• First release of zForce Programmer 1.1.0.0

Main Features

• Full support for NTSMF 2.2 
• Backwards compatibility with NTSMF 2.0, 2.1.

• CLI Support

• Visualizer

• Bug fixes and performance.

• Rename of min/max touch active area parameters

• Additional persistent parameters

• If the wrong DFU driver is detected, you can now install the correct one for the running sensor from inside zForceProgrammer. Requires Administration privileges.

Known Issues

• Reading and writing parameters does not work before leaving DFU/Config mode in the following cases:

  • After updating DFU drivers.

  • After starting zForceProgrammer with a sensor plugged in that is already in DFU/Config mode.

  • After plugging in a sensor, while holding down the DFU button on the interface board.